Could somebody with the Spectrum Bachmann 2-6-0 please measure the driver diameter for me?  I am hoping that it is the same as the low boiler 4-6-0, so that I can replace some or all of the drivers.  I like the counterweight style on the 2-6-0 a bit better, as it will be a little easier to modify for my purposes.

Hi,

I am looking for 80" HO scale boxpok drivers for a GS-4 rebuild project.  

I don't really care for the warranty option given by Bachmann for my early loco.  Mind you, it is fair, I just don't like the option.  

I'm hoping to use 3-d printing to replace the crummy split axles, but so far no follow up responses from the 3-d printer folks.

All of the usual folks either don't have them, stopped making/carrying.

Well a week ago I figured I would be done with this in a couple days. Between being busy in real life and grossly underestimating the amount of work I had left, I just finished the grain elevator this evening. I'm pretty happy with how it turned out. The silos, headhouse, and shed are still separate pieces until I fine-tune their location on the layout.

Hey everyone, I am struggling on the design of my yard.... look this over and give me some suggestions. It is loosely based on Juniata / Conrail. Needs to handle 10ft trains, have engine service buildings, fuel and sand facilities and classify trains. 

Does it work better with the mainline in the front or rear?

Thank you, sorry about the poor drawing but Autocad didn't create a PDF very well...