Has anyone out there changed over the Bachman New York Central System GP-7 to a   Peoria + Eastern  GP-7 ??   Just curious. One would removed the road number under the cab window and replace with the P+E oval emblem. Plus larger block numbers by the corner of the side short hood. Does anyone make decals for these P+E locos ??

I have a pile of Accurail box cars to make. Two of them are 40' wooden ones with the upright type of brake wheel. You get a piece of wire to cut to length and then have to balance the wheel on the end using whatever glue you have. 

I tried using CA but all that happened was that my fingers got stuck as well. I am now using Gator's Grip (an acrylic based glue that works with resin and metal) but even then it is difficult to get the wheel on straight. I am not keen on trying to drill a tiny hole.

I have recently bought 11 Accurail kits. They are very nice and go together well but I have had a problem with one kit in that there are no flanges on one of the wheelsets. I am in the UK so this isn't quite a trivial problem.

It was recommended to me when I was asking about these kits that I get some replacement wheels and couplers. I got the couplers but didn't buy the wheels (D'oh!). I am looking at getting a set of replacements and have seen the following on offer.

I hope this is an easy one.  Can anyone verify (or refute) that both versions of the Spectrum 4-6-0 as well as the 4-4-0 share the same cab?  I know that there are a couple different cabs offered, but are they interchangeable?  I suspect that they are, but I'd like to know for sure.