I have a Genesis F-3. I pulled the MRC sound out of it, and replaced it with a TSU-GN 750. Well the engine before would run, lose sound, and start up again. I thought it was the decoder, but it is still doing it. I looked at the wheels and they do not look dirty, but tomorrow i will clean them. If it still does it, I will be at a loss. Has anyone ever experienced something like this?

If it still does it, I guess I will have to send it off to be repaired. Sigh... frustrating.

Jim Lowery

We are pleased to announce a new product to our line, the Signal Tester. If you have LED-based signals that you want to test or if you have a signal with unlabeled magnet wire (e.g. BLMA) then this is the product you need! You can also use it to show off one of your signals for simple display purposes. The Signal Tester uses a 9V battery (not included) for power and is simple to use. More information about this product can be found on our website at http://www.logicrailtech.com.

I wasn't real sure where to put this, so here it goes...

i don't know if this is standard, but both ends of the tender appear to be glued on. Wow! it was very difficult to get it/them off. Iwas finally able to, but wow was it frustrating. Is this standard? I did not run into this problem with the same tender on my Spectrum 4-8-2.