the MRH Forum

Help finding Smokebox Cover for Brass Mohawk Journals/Blogs
Reply
Regular poster 160 posts s_brown Regular poster 160 posts
s_brown

I recently acquired a Brass samhongsa loco that appears to be an L4 Mohawk.

The loco came with out the front smoke box cover and my initial measurements come to 29.04mm (measured with vernier gauge) with roughly translates to 99inch in prototype. I also need a tender ladder but that's easy

I have found parts at greenwayproducts.com which have some covers but only seem to have up to 92inch covers.

Can anyone suggest other supplier(s) that may have parts.

I've hopefully embedded the image below if anyone can help would appreciate it, also if my identity is wrong would also appreciate the correction

Thanks

Simon

 

Simon
Melbourne Australia
Modeling the UP - steam to diesel 
Reply 0
jlewisf3 Active Member 55 posts
jlewisf3

Mohawk smokebox front

Simon: Is the boiler front round, flat on the bottom, or perhaps sporting a couple of semicircular cuts out of the bottom quarters? If it is flat on the bottom, like a Niagara, I think that PSC may make a part to fit. Jeff Fry Centennial CO
Reply 0
s_brown Regular poster 160 posts
s_brown

Smoke osx shape

Hi Jeff thanks for reply. It has two semi circular cut outs in bottom quarters. I've had a close look at my BLI hybrid Mohawk and appears same. I an get a part from BLI parts as have just had response from them too. Thanks Simon

Simon
Melbourne Australia
Modeling the UP - steam to diesel 
Reply 0
Reply