the MRH Forum

This may be easy but I just dont know Track and electrical/DCC
Reply
New member 9 posts iamwhiteshadow New member 9 posts
iamwhiteshadow

Hi all, I’m a new guy to the group and DCC (Yea)  I’m catching on slowly and even though I know how to do searches I cant find anything on the internet or with the guy at the store that explains a few things that would seem important to any and all. Like this, I just got the NCE power cab, then the Proto 2000 Diesel EMD F7 A and B SOO line set, I want to put a Tsunami TSU 1000 in this bugger but I cant find the answers to my questions anywhere. 1, can I pull the plug with the 9 wires out of the tsunami and plug it in to the 9 pin plug on the smaller board at the end of the wires coming from the longer board, or do I remove both boards and do a hard wire from scratch, or do I solder the Tsunami to the longer board, and do I have to remove the smaller board? This is starting to drive me mad lol. So if anyone would care to help me threw this I would be very grateful. PS the store couldn’t even answer this so……… Thanks
Reply 0
jlrc47 Regular poster 401 posts
jlrc47

Plug the Tsunami in

Since you are new to DCC I think you try just to Plug the Tsunami into the factory board.

Or remove everything and hard wire the Tsunami.

Also check out Bruce's website Mr.DCC University

http://www.mrdccu.com/curriculum/soundtraxx/tsunami.htm

gniture1.png 

Amherst Railway Society   HHJ YouTube channel

 
Reply 0
iamwhiteshadow New member 9 posts
iamwhiteshadow

Thanks Joe (jlrc47)

Thanks for the advice I'm going to check the link and look for definite answers. if I find them I'll share with the group. Thanks for the help.
Reply 0
iamwhiteshadow New member 9 posts
iamwhiteshadow

I removed the pre installed

I removed the pre installed boards and hard wired the Tsunami, I changed all CV's I could find but the volume is very low. I have a Digitraxx with a round cheap speaker that is two times as loud. ?
Reply 0
Reply