I have been using EZ command with success for 3 years.  Recently, I added a walk around companion throttle.  It worked flawlessly when connected directly to the controller.  I wanted to operate from another location on the layout so I purchased the remote connector panel (with cable).  I installed it according to directions (although quite simple) and plugged in across the layout.  Some of the locomotives worked, but the forward direction light did not light any longer (locos still run) and several of locos didn't light up or run.  I tried plugging the companion back into the controller directly and still have problems as described above.  I tried powering everything off, unplugging and plugging, etc.  I also tried the second port for the IO connection.  No luck.
Is there a reset for the controller or companion.  The controller still works fine by itself.
Thanks for any help you may provide.
John
from the Oregon River and Beaver Junction Railroad (based on the MRR beer line from 2009)